The use of high-speed printing die cutting machine should pay attention to the following issues:
2023-02-21
1. The depth of the die cutting machine into the rubber pad cannot be too deep, and the size cannot exceed 1.2mm.
2. When the mold is not produced, be careful to keep it. It is suggested not to put it on the ground, but to make a bracket to hang it for storage.
3. When installing the mold, try to use each screw hole position.
4. Change the position of the rubber pad frequently to make it smooth and extend the service life of the rubber pad; even if it is equipped with a grinding and cutting device, do not wear it too deeply, just grind off the rough surface.
Among them, several important parameters of high-speed printing die cutting machine are introduced as follows:
1. Wood board: three-layer board 16mm, five-layer board 13mm.
The height of the standard die-cutting machine is 24.64mm and 25.4mm, the latter is mostly.
3. Die cutting steel wire: height = knife height-corrugated cardboard flattening thickness-correction value (the depth of the knife cutting into the rubber pad). Thickness The flattened thickness of corrugated board.
4. Guard: The height should be 0.5 lower than the steel wire, and the hardness should reach about 60 Rockwell hardness, so as to crush the ridge near the steel wire well.
5. Sponge: It is recommended to be granular and evenly distributed around the knife. The elasticity is good, the hardness is about 35, not the more sponges, the better. Put a hook in the narrow pit. These five points are the five basic elements to ensure the size of the high-speed printing die cutting machine. As for the height of the hob, the theoretical diameter of the die, and the depth of the hob cutting into the rubber pad, they can all be fixed and controlled.
I believe that through the above introduction, we also have a lot of understanding of high-speed printing die cutting machine. We are the manufacturer of high-speed printing die cutting machine, if you want to know more about this aspect, please contact us. We can introduce you from different aspects.
TAG:
Recommended News
Service hotline
Cangzhou Mingyang Machinery Co., Ltd
Tel: 8615903277888
Email: christina@mingyang-machinery.com
Address: Room 1108, Building S4, Cangzhou Wuyue Plaza, Yunquan District, Cangzhou City, Hebei Province
